Dyno PVL Aluminum Racing Flywheel for GX160, GX200, 6.5 OHV, and BSP Clones

Safety and Performance at an affordable price!

PVL is known for making quality flywheels. This flywheel is dynamically balanced, and has been tested by PVL at 17,000rpm. The steel center hub adds durability to keep from damaging the taper. The center hub also has tapped holes for the use of a flywheel puller.

The PVL flywheel fin design allows it to move a very high volume of air. The flywheel works with the standard OEM clone coil with a recommended coil gap of .038-.040". The running timing with a straight-up key is 28 degrees, and it is recommended to start with a running timing between 28-31 degrees.

PVL, the manufacturer, tested the flywheel at 17,000rpm, and an independent company in the USA tested the flywheel at 15,000rpm for 60 minutes, both without failure. These tests do not verify or guarantee the safety, suitability, use, or the fitness of this flywheel. Racing is dangerous, and exploding parts can cause injury or death.

Flywheel Removal
The flywheel comes with two 5/16-24 threaded holes in the steel hub for the use of a standard 2 bolt puller for removal.